Step 1. Disconnect battery terminals
Step 2. Lower the steering colum
Step 3. Remove the 2 screws that hold the guage cover and remove cover
Step 4. Remove the 3 screws that hold the gauge cluster in
Step 5. Disconnect 3 electrical connectors on the top of the cluster and remove cluster


*Remove clear plastic cover by pushing down on tabs.
Remove trim.
Remove plastic cover on the rear of gauges by pushing down on tabs on edge and in center of cover.
pry up the little silver clamps that hold the gauges in.
Push the gauges out On back of circuit board
Using q tips and accetane remove the green film from desired areas.
Re insert gauge faces and attach by pushing tabs back down on back of circuit board.
Reattach circuit board cover.
Reinstall trim
Reinstall plastic cover.

* I discovered that if you use LED bulbs it is not necessary to remove green film. It will Just be a darker blue*

Step 6. Remove bulbs from cluster by turning ¼ turn
Step 7. Rplace bulbs and reinsert to gauge
Step 8. Reconnect electrical connectors
Step 9. Reconnect battery terminals
Step 10. Check bulbs for operation
Step 11. Insert the 3 screws to secure gauge cluster
Step 12. Inset cover
Step 13. Reinstall 2 screws to secure cover
Step 14. Return steering column to desired position

Finished project


Here is the video that I used