Datalog COBB AP

[Omegared99]

https://docs.google.com/spreadsheet/...WpuLWVLRGkzblE
https://docs.google.com/spreadsheet/...0pBUFNxMUFYRGc
https://docs.google.com/spreadsheet/...DBudE1ac1hvaVE
https://docs.google.com/spreadsheet/...VVfNWxNMUtaa3c
https://docs.google.com/spreadsheet/...0JoNnlSajlvTkE


Ok here it goes again. Hope these turned out right my homie is new to the AP so ugh here it is

[Omegared99]

looks as though i may have loaded two of the same not sure

[Omegared99]

Why do i get the feeling i F*(K UP somewhere on these logs

[Omegared99]

so found out my map supports upgraded tmic :-)

[HolyCrapItsFast]

They look alright now... There is some knock in the low load region but I wouldn't worry about it just yet. Perhaps drive around for a couple days to let it accumulate learned data then take another log. When you do, give us one (1) WOT in 3rd gear from 2400-6000 rpm AND one (1) WOT in 4th from 2400-6000 rpm.

I need you to stick to the following parameters though. Please don't log anything else, just these. The AP is horribly slow and the more data you log the slower it gets.

Rpm
Calculated Engine load
A/F correction 1
A/F learned 1
A/F sensor ratio
Throttle position
Maf voltage
Feedback knock correction
Fine learned knock correction.

So good luck and I will check back in a day or so.