Once everything is painted and your ready to re-asemble, put together the front half of the headlight screws and all, then try to re-attach this portion to the read half of the headlight. Bake for another 10 minutes at the same temperature, and slowly work the headlight back together, I used two large racheting clamps with rubber heads to help hold each side together. MAke sure if you think that the glue originally holding the light together wont be enough, add some black silicone gasket to the ridge just before putting them back together. My headlights didn't require any more glue than what was originally there. So if you are careful and reheat the glue for the right time you should end up with the same result. Here's my final result