This is a simple guide on how to debadge your trunk.
Note: The pictures I have used are not mine, I do not have any rights over them. I am not responsible for any damage done to your vehicle.
Skill level: 1/5
Time Needed: 10-20 min
Tools:
-Fishing wire or dental floss
-Heat gun (you dont need this if your car has been in the sun for a few hours.)
-Adhesive remover
-Paper towels and water
Step 1: The first thing you have got to do is clean the area where you will be doing the de-badging.
Step 2: Use the dental floss and try to get it under a corner of any of the letter and slowly, using an up and down motion go though the badge. *Make sure not to break any of the lettering, by going to fast or pulling out (towards you) while doing the up and down motion.* By the up down motion, I mean use it like a saw.
Step 2 (With Heat gun): Make sure you do not apply too much heat or it will ruin your paint, do it enough just make the badge wiggle a bit.
After removing badge:
Step 3: Before you use any adhesive remover, try to get most of the residue of with your finger by rubbing it.
Step 4: Use adhesive remover to get all the remaining adhesive off.
Result:
All credit goes to original poster: http://www.wrxtuners.com/forums/f93/...ictures-15978/
Bookmarks